I've been searching on here but can't find a definitive answer.
Can I turn off cold check for my reverse lights? The led's are throwing up a warning.
Bit of guidance please - I have a genuine micro-can VCDS cable (had it for years, Golf V and Touran owner for airbag lights, coding cruise, navigation, door locks etc etc), and have just bought a 2007 Roomster Scout.
I understood that this car supported canbus diagnostics and that the cable would work.
I have connected the cable today, checked the interface and saved - but none of the cars modules are seen.
What am I doing wrong folks?
Hello all,
Firstly, I've no symptoms or issues when driving. But if I do a change on VCDS I always run a scan before and after. (just enabled cornering fobs).
I've got the two following fault codes:
1) 1 Fault Found:
21419 - Internal Control Module Error
P2610 00 [032] - Engine Shut-down Timer
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
2) 1 Fault Found:
10763 - Starter Enable from Selector Lever Sensor System
P1734 00 [002] - -
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
I've done a search and nothing really has come back that suggests what the reason for this is, as I've got no warning lights or symptoms, I'm not overly worried just wondered what they mean.
Anyone have any idea?
Thanks
Mike
See below code shot - removed number plate and VIN
Sunday,10,April,2016,16:25:10:51990
VCDS -- Windows Based VAG/VAS Emulator Running on Windows 10 x64
VCDS Version: 15.7.4.1 (x64)
Data version: 20160216
www.Ross-Tech.com
VIN: License Plate:
Mileage: 11903km-7396mi Repair Order:
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Chassis Type: NE (5Q0)
Scan: 01 02 03 08 09 10 15 16 17 19 36 42 44 52 55 5F 69 6D A5 A9
VIN: Mileage: 11903km-7396miles
01-Engine -- Status: OK 0000
02-Auto Trans -- Status: OK 0000
03-ABS Brakes -- Status: Malfunction 0010
08-Auto HVAC -- Status: OK 0000
09-Cent. Elect. -- Status: OK 0000
10-Park/Steer Assist -- Status: OK 0000
15-Airbags -- Status: OK 0000
16-Steering wheel -- Status: OK 0000
17-Instruments -- Status: OK 0000
19-CAN Gateway -- Status: OK 0000
36-Seat Mem. Drvr -- Status: OK 0000
42-Door Elect, Driver -- Status: OK 0000
44-Steering Assist -- Status: OK 0000
52-Door Elect, Pass. -- Status: OK 0000
55-Headlight Range -- Status: OK 0000
5F-Information Electr. -- Status: OK 0000
69-Trailer -- Status: OK 0000
6D-Trunk Elect. -- Status: OK 0000
A5-Frt Sens. Drv. Assist -- Status: Malfunction 0010
A9-Struct. Borne Sound -- Status: OK 0000
-------------------------------------------------------------------------------
Address 01: Engine (J623-CHHB) Labels: 06K-907-425-V1.clb
Part No SW: 5G0 906 259 C HW: 06K 907 425 B
Component: 2.0l R4 TFSI H13 0001
Revision: --H13---
Coding: 0C1D00122434010B0000
Shop #: WSC 73430 031 00000
ASAM Dataset: EV_ECM20TFS0205G0906259C 001004
ROD: EV_ECM20TFS0205G0906259C_SK37.rod
VCID: 2E581FB371DC534EDC-807A
1 Fault Found:
21419 - Internal Control Module Error
P2610 00 [032] - Engine Shut-down Timer
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
Readiness: 0000 0000
-------------------------------------------------------------------------------
Address 02: Auto Trans (J743) Labels: 0D9-927-770.clb
Part No SW: 0D9 300 041 C HW: 02E 927 770 AQ
Component: DQ250-6F MQB H53 4902
Revision: 06253104 Serial number: TFK01506231402
Coding: 0014
Shop #: WSC 73430 031 00063
ASAM Dataset: EV_TCMDQ250021 001001
ROD: EV_TCMDQ250021_AU37.rod
VCID: 1834D96BE358BDFEA6-804C
1 Fault Found:
10763 - Starter Enable from Selector Lever Sensor System
P1734 00 [002] - -
Intermittent - Not Confirmed - Tested Since Memory Clear
Freeze Frame:
-------------------------------------------------------------------------------
Address 03: ABS Brakes (J104) Labels: 5Q0-907-379-ESP-V1.clb
Part No SW: 3Q0 907 379 T HW: 3Q0 907 379 C
Component: ESC H32 0393
Revision: 00000000 Serial number: 51885000002675
Coding: 1C07939154242974007F060941C32938C92A9400608294F600410070C009
Shop #: WSC 73430 031 00063
ASAM Dataset: EV_Brake1UDSContiMK100ESP 034033
ROD: EV_Brake1UDSContiMK100ESP_SK37.rod
VCID: 4B9E7627E20E0666DB-801E
1 Fault Found:
16401 - Tire Pressure Warning
C102D 00 [008] - -
Intermittent - Confirmed - Tested Since Memory Clear
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 2
Reset counter: 3
Mileage: 8025 km
Date: 2016.02.14
Time: 22:09:42
-------------------------------------------------------------------------------
Address 08: Auto HVAC (J255) Labels: 5G0-907-044.clb
Part No SW: 5E0 907 044 R HW: 5E0 907 044 R
Component: Climatronic H04 1002
Revision: 00001K07
Coding: 02110004000100011005000000101000
Shop #: WSC 73430 031 00000
ASAM Dataset: EV_ACClimaBHBVW37X 004131
ROD: EV_ACClimaBHBVW37X_SK37.rod
VCID: 346C0DDB9FF0799EAA-8060
No fault code found.
Hi car running poorly despite new turbo
1.9 PD BXE Octavia 2
Took attached log tonight at max. accel.
JPEG shows graph
Thinking it looks OK but not really sure what ideal should be like so would value your thoughts.
Recirc. duty cycle has got me confused though - I get it that it should be high during max. accel. It was high - totally constant at 95.5% but I would have thought it should have been 100%. Again your thoughts and experience appreciated.
Could this cause poor running?
Have just bought (Legit) HEX + CAN VCDS so I am new to all this
Thanks
Hi, after my elm 327 finally arriving I have put torque light on my tablet to check the timing advance as I suspect it could be better.
The reading is 63.5 degrees.
This doesn't sound right and thought it should show a +/- figure.
What is it supposed to been degrees?
Ps its a Mk1 fabia estate 1.4tdi
HI Guys,
I just bought an S3 intercooler to get me up to stage 2. but it came without any pipework. I need to fit it to a octavia vrs 2.0l tfsi 2006. Has anyone got any ideas what pipework i need and which to go for.
Heeelllllp. I got to fit it on Wednesday
C
I have a recently purchased VAG-COM from ross tech and i need to do a FORCED DPF REGENERATION on my vehicle but it wont give the security access code when i highlight the box. I have tryed the security access code which should work for all diesel engines which 12233 but doesnt work can anyone help?
Vehicle details:
Skoda Octavia vrs tdi
year: 2007
engine: 2.0tdi 170pd
Afternoon folks 
I'm currently toying with the idea of getting a genuine ross-tech cable - as it's personal use, i'd probably only ever use it on my own car, so the 10 VIN option is a bit overkill, and need some help to make up my mind. The problem is, that I have no issues paying someone to make changes, and travelling - regularly travel with work anyway, my problem is that i'm a bit of a geek, and having a particularly addictive nature, if I started changing things, I wouldnt be happy with a list of 2, 3, 4 things, etc and that'd be the end, i'm far more of a tinkerer.
The issue is a bit more diluted - I dont need the cable for any bog-standard OBD functions - I have a custom Android app I wrote for the daily-grind stuff... so purely for coding - given enough time, I could maybe modify my app to do what I need to - time vs effort vs results in that instance probably isnt worth it.
What I want to do, but need confirmation they work are....
1. Traffic Sign Recognition
2. HBA
3. Passenger Side Mirror drop on reverse
4. Battery Voltage display
5. 'Driving School' display mode on MIB2
6. Disable the f***** AM band on the radio !
7. DRL Flash out of phase with indicators
Other things I would like the option of having
A. Change the lower speed threshold for Lane Assist - currently just around 38 - 39mph, but think it would be useful at 28 - 29mph
B. Change the Start/Stop from 'press to disable' to 'press to enable'
C. Have ESC in Sport ESC by default
D. The 'off-road' screen from the Sup3 - just for the hell of having the display show something interesting when I dont need / get bored with maps...
E. The 'Driving Profile' display on the maxi-dot as per the Sup3 adaptions
I have a Octavia vRS mk3, IIRC, wk27/2015, it's definitely a MY2016 with MIB2.
On top of the factory fitted options like lane-assist, etc...
- Front Parking Sensors
- Colour Maxidot
- Amunsden
Hopefully someone can give a yes/no on points 1 - 7 on a vRS with similar kit, and experience on success or failure for A - E - assumptions can be made and theorised with good justification
Hope someone can sort this out and justify one way or another
Figured how to disable the feature but decided to enabled it again, How do i extend the wash from every 5 (i think it is) washes of the windscreen to something like 10 times that then triggers the headlight wash ? thanks.
